BONDING

Railway Train detection

adminLeave a Comment on Railway Train detection

RAILWAY TRAIN DETECTION |SYSTEM SAFETY|PERFORMACE REQUIREMENTS|OCCUPATIONAL SAFETY|MAINTAINABILITY|RELIABILITY|OCCUPATIONAL SAFETY|ENVIRONMENT|DISCRETE SYSTEM|CONTINUOUS SYSTEM|MOVING BLOCK SYSTEM|BLOCK SYSTEMS|LEVEL CROSSING| BONDING Railway Train detection PERFORMACE REQUIREMENTS SYSTEM SAFETY OCCUPATIONAL SAFETY RELIABILITY MAINTAINABILITY ENVIRONMENT SYSTEM SAFETY -GENERAL   SYSTEM SAFETY SAFETY INTEGRITY LEVEL SAFETY PERFORMANCE BENCH MARK SERIES TRACK CIRCUIT BONDING OVERCURRENT PROTECTION INSULATION AND ISOLATION SURGE ARRESTERS POSITION OF TRAIN DETECTION […]

Continue Reading
Center Fed AFTC

Railway Audio Frequency Track Circuits

admin3 Comments on Railway Audio Frequency Track Circuits

ALLOCATION OF FREQUENCIES| RAILWAY AUDIO FREQUENCY TRACK CIRCUITS |PRINCIPLES OF THE OPERATION|QUADRUPLE LINES|TRANSMITTER -Tx|RECEIVER -Rx|TUNING UNITS|CENTER FED AFTC| TRACK CIRCUIT LENGTHS|TRACK CIRCUIT LENGTHS|PHYSICAL REQUIREMENTS|WIRING DIAGRAM| CONFIGURATIONS OF AFTC Railway Audio Frequency Track Circuits It’s a type of AC track circuit in which audio frequency signals are used instead of pure AC or DC signals. Its […]

Continue Reading
Introduction of British Railway Signalling

Introduction of British Railway Signalling

adminLeave a Comment on Introduction of British Railway Signalling

Introduction of British Railway Signalling Essentials of Interlocking 1. The essentials of safe and efficient signalling system are: 2. The concentration of control of points and signals in a signal box. 3.The interlocking of points and signals. 4. Electric/telegraphic communication between adjacent signal boxes. 5. The block signalling system and the regulations for its operation. […]

Continue Reading
Receiver Coil Output

Railway Single Section Digital Axle Counter CEL DACF 710 A & DACF 710 P

admin1 Comment on Railway Single Section Digital Axle Counter CEL DACF 710 A & DACF 710 P

Railway Single Section Digital Axle Counter CEL DACF 710 A & DACF 710 P The system comprises trackside counting units, installed at both ends near the detection points on the track. No separate evaluator is required. Two versions available (i) DACF 710 P (Phase reversal type) The DACF 710 P is not affected by the […]

Continue Reading

Railway Signal positioning & Visibility

adminLeave a Comment on Railway Signal positioning & Visibility

Railway Signal positioning & Visibility Signal Positioning and Visibility GE/RT8037 – Signal Positioning and Visibility This Standard contains mandatory requirements for positioning signals and indicators to ensure adequate viewing and clarity of meaning for drivers. GE/GN8537 – Guidence on Signal positioning and visibility. This document supports GE/RT8037 and provided guidence on the requirements for positioning […]

Continue Reading